Wireless products from Banner
Wireless products from Banner connect remote assets with the people who manage them, enabling real-time monitoring and management of equipment and conditions in difficult-to-access locations or where wired solutions are impractical, ineffective or cost-prohibitive.
Easily replace discrete, analog, serial, and ethernet signal wires. With no setup software needed, data radios are easy to apply, use, and support. With wireless I/O, you can create expandable point-to-multi-point wireless networks that distribute I/O over large areas.
Q45 Series All-In-One Kits for Predictive MaintenanceQ45 Series all-in-one kits combine a wireless node, sensor, and battery power supply in one easy-to-deploy device that monitors assets and equipment in remote and hard-to-access locations.
All-in-one design eliminates the time, labor, and expense of installing separate sensors and nodes
The Q45VA all-in-one vibration and temperature sensor and wireless node monitors the health and performance of motors, pumps, and similar equipment with rotating motion
The Q45UA all-in-one ultrasonic sensor and wireless node monitors the level or position of fluid or dry assets in tanks, totes, and containers
Use with Connected Data Solutions cloud software to create an end-to-end IIoT solution that will help you identify and resolve problems more quickly and make better, data-driven decisions
Performance Series Gateways and NodesCreate point to multi point networks that distribute I/O over large areas. Input and output types include discrete (dry contact, PNP/NPN, float), analog (0 to 10 V dc, 0 to 20 mA), temperature (thermocouple, thermistor and RTD), AC/DC relay (SPDT) and asynchronous counter (up to 10kHz).
High density I/O capacity provides up to 12 discrete inputs or outputs or a mix of discrete and analog I/O
Universal analog inputs allow current or voltage to be selected in the field
Power, control and monitor AC powered devices using AC/DC relays and courtesy power
DX80 MultiHop ModbusMultiHop Modbus Data Radios extend the range of Modbus or other serial communication networks. Each radio may be set to act as either a master, repeater or slave. Models are available with input and output types including discrete (dry contact, PNP/NPN), analog (0 to 10 V dc, 0 to 20 mA), temperature (thermocouple and RTD), AC/DC relay (SPDT) and asynchronous counter which can be accessed using the Modbus protocol.
Self-healing, auto routing RF network with multiple hops extends the network’s range
Flexible: dip switch selectable to be a master, repeater or slave
User-selectable communication between RS-485 and RS-232
PM Series – Wire ReplacementAn I/O Radio network that combines long range line-of-sight coverage with ease of deployment and use.
The PM Series provides a flexible network that easily sets up without software. Setting up a basic point-to-point network is as easy as pairing a cell phone to a headset. You can replace cables and extend the range of digital and analog signals with minimal effort.
No software needed
Menu-driven LCD user interface
Choose from two I/O configurations
Select from multiple I/O maps
One gateway is preconfigured to support up to two (PM2) or six (PM8) nodes
IP67 rated housing for demanding environments